WM

SPRAY CHARACTERISTICS

• Uniform distribution with finest possible atomisation using direct liquid pressure alone.
• The standard spray angles of 40°, 60° or 80° are the nominal angles close to the nozzle orifice.
• For small capacity tips up to say 8 litres/hour the angle falls off rapidly a few inches from the tip. The larger the tip size the further the nominal angle projects before the spray begins to fall away.
• The nozzles produce a hollow cone spray but with the small capacity tips the spray rapidly merges into a “Solid” cone type.

CONSTRUCTION AND MATERIALS

• Nozzle tips precision machined to ensure most perfect spray available at low throughputs.
• Internal distributor, screw pin and strainers are renewable in most sizes.
• Available in Brass and 316 Stainless Steel as standard.
• Nozzle has 1/4″ Male BSPT thread as standard.
• Other materials available to special order.

ORDER EXAMPLE

WM 1408 Brass.

Maximum Recommended Pressure: 35 Bar.G.}