NordicNozzle | AC
16302
post-template-default,single,single-post,postid-16302,single-format-standard,ajax_fade,page_not_loaded,,vertical_menu_enabled,side_area_uncovered_from_content,qode-theme-ver-16.9,qode-theme-bridge,disabled_footer_top,wpb-js-composer js-comp-ver-5.5.5,vc_responsive
 

AC

27 May AC

Posted at 20:31h in FLAT SPRAY, INDUSTRIAL SPRAY NOZZLES by
0 Likes

SPRAY CHARACTERISTICS

  • Produces a uniform, flat spray pattern without hard edges at pressure of 0.5 bar and up.
  • Tapered edges of pattern allow overlapping for even distribution.
  • Impact of spray is generally greater with narrow spray angles assuming equal flow rates.
  • Available spray angles of 0°, 15°, 25°, 40°, 50°, 65°, 80°, 90°, 100° and 110°

CONSTRUCTION AND MATERIALS

  • One piece Male BSPT thread design (1/4 and 3/8″ Femals BSPP threaded body available to order).
  • Hexagon body with wrench flats avoid distortion when tightening.
  • Tapered inlet reduces wear and resists clogging.
  • Brass, Stainless Steel and Hardened Stainless Steel.
  • Other materials available to special order.

ORDER EXAMPLE

1/4″ ACM (Male) 6.5-15° Brass.

3/8″ ACF (Female) 60-80° Stainless Steel.

Maximum Recommended Pressure:

100 Bar.G. (Metal)

CAPACITY CHARTS

 

No Comments

Sorry, the comment form is closed at this time.